Measurement of single-phase network parameters including voltage, current, active-reactive & apparent power, cos, tg and frequency.
The N30P is an 1/8 DIN (48 x 96mm) power meter that has the ability to display values in three different colours (yellow, green and red) depending on the measured value in the range. This is extremely useful when the display colour can indicate below, on, and above a set value or range.
Programming of the meter can be achieved via the keyboard or through the RS-485 interface by means of the free LPConfig software program. The N30P can have up to 4 alarm outputs with front panel display indication, operating in 6 different control modes. Minimum and maximum values of all measured values can also be stored.
Once registered, you will be redirected to this page, and you won't have to register again to access files on this site.
Back to top