What is a Thyristor?

A thyristor is a semiconductor device which acts as a switch. However, when switched on it can only pass current in one direction. It is in fact a switchable diode sometimes known as a silicon controller rectifier (SCR). To switch alternating current (AC) two devices are connected in inverse parallel.

Each device is turned on at the appropiate time by a trigger pulse applied to the gate and the device will remain on until the instantaneous load current through it drops to zero. The trigger pulses are generated by a driver, which times the pulse to ensure the thyristor unit output is a function of the input demand signal firing mode.

firingthyristor.jpg

 

To look at typical thyristor power controller loads & applications, try our Thyristor Application Product Selector and automatically see what product we consider to be ideal for each application and element type. Alternatively visit our Thyristor home page for more thyristor information.

 

The Basic Firing Modes

 

 

Zero Crossing (ZC)

 

firingZC.jpg

The ZC firing mode is used with the logic output from a temperature controller, for example, and the thyristor operates like a contactor. The cycle time is determined by the temperature controller. ZC minimises interference due to the fact that the thyristor unit switches ON and OFF at zero volts.

Burst Firing (BF)

 

firingBF.jpg

This firing is performed digitally within the thyristor unit at zero volts, producing no EMC interference. Analogue input is necessary for BF and the number of complete cycles must be specified for 50% power demand. This value can be between 1 and 255 complete cycles, determining the speed of firing. When 1 is specified, the firing mode becomes Single Cycle (SC).

Single Cycle (SC)

 

SC is the fastest zero crossing switching method. At 50% input signal, one cycle is ON and one cycle is OFF. At 75%, 3 cycles are ON and one cycle is OFF. If power demand is 76% the unit performs the same as for 75% but every time the unit switches ON the microprocessor divides 76/75 and memorises the ratio. When the sum is one the unit delivers one cycle more to the load.

firingSC.jpg

With this firing it is necessary to have an analogue input. SC is ideal for simple resistance loads and where thermal mass of the load is small or as a low noise alternative to PA firing with some applications.

 

Phase Angle (PA)

 

PA controls the power to the load by allowing the thyristor to conduct for part of the AC supply cycle only. The more power required, the more the conduction angle is advanced until virtually the whole cycle is conducting for 100% power. The load power can be adjusted from 0 to 100% as a function of the analogue input signal, normally determined by a temperature controller or potentiometer,

firingPA.jpg

PA is normally used with inductive loads. Filters may need to be used to remove any resulting interference generated.

 

Have you tried our Application Product Selector to automatically find the right thyristor for your application? or for more thyristor information visit our Thyristor home page.